Skip to content
Civic Water EngineeringSTART A PROJECT

Borehole Development

Borehole Yield Testing

Yield testing measures how much water a borehole can supply and how quickly the water level recovers after pumping. CWE uses the results to recommend a pumping rate, pump size and storage capacity.

START A PROJECT 010 730 0051
  • Step and constant-rate tests
  • Water quality sampling
  • Clear abstraction recommendation
Test-pumping setup with a flow meter at a borehole head on farmland

Why test first

Test before you equip

A blow yield during drilling gives only a rough indication. Equipping a borehole on that figure risks an oversized pump that runs dry, burns out or damages the borehole.

A proper pumping test shows how the water level responds over time and how quickly it recovers, giving a defensible sustainable yield.

Water-level dipper tape lowered into borehole casing during a pumping test

Test types

Which tests are run

Tests are selected to suit the borehole and the intended use. Larger abstractions and critical supplies warrant longer tests.

Pumping tests

TestWhat it shows
Step testHow drawdown changes at increasing pumping rates
Constant-rate testAquifer behaviour over an extended period at a fixed rate
Recovery testHow quickly the water level returns once pumping stops
Quality samplingChemical, physical and microbiological water quality

Results

How the results are used

The test report gives the recommended pumping rate, pumping hours and equipment requirements.

Results inform

  • Pump selection and installation depth
  • Recommended daily abstraction and pumping hours
  • Storage volume to balance supply and demand
  • Treatment requirements from the water analysis
  • Water-use registration information

Yield testing questions

Common questions about pumping tests.

Talk to a specialist

010 730 0051START A PROJECT

How long does a yield test take?

Duration depends on the borehole and its intended use. Short tests suit small domestic supplies; larger or critical supplies need longer constant-rate and recovery tests.

Can an old borehole be tested?

Yes. Existing boreholes are often tested before re-equipping or when a site's demand changes.

Is water quality tested at the same time?

Yes. Samples are taken during the test and analysed by a laboratory so treatment needs are known early.

What happens if the yield is low?

The system is designed around it, for example with longer pumping hours, more storage, or an additional source.

Related services

Borehole Drilling & Development

Full borehole development from siting to equipping.

Read more

Borehole Siting & Geohydrological Surveys

Geohydrological surveys to choose the drilling point.

Read more

Borehole Water Treatment

Treatment designed from the water analysis.

Read more

Water Storage & Distribution

Storage sized to balance yield and demand.

Read more

Book a yield test

Share the borehole location, depth if known and how you plan to use the water.

010 730 0051enquiries@civicwater.co.za
PROJECT ENQUIRYALL FIELDS MARKED * ARE REQUIRED